| 防腐地坪的施工工艺 |
| 添加时间：2018/9/1 15:36:53 浏览次数： |
| 基础处理：采用打磨机对浮物，凹凸不平的地面进行深度打 防腐地坪磨，清理灰尘杂物，如果凹入太深的区域用中涂层材料加石英砂修补，找平，固化后再进行底涂层施工； Foundation treatment: the use of grinding machine for floating objects, uneven ground deep grinding anti-corrosion floor grinding, cleaning up dust and debris, if concave into too deep areas with medium coating material and quartz sand repair, leveling, solidified and then undercoat construction; 02 02 底涂层：用树脂胶料加适量稀释剂滚涂一遍，增加附着力以及封闭基础地面的潮气，水气，避免基础层与环氧涂层起壳，脱层； Primary coatings: with resin adhesive and a suitable amount of diluent roll coating, increase adhesion and seal the moisture, moisture on the ground, to avoid the base layer and epoxy coating shell, delamination; 03 03 玻纤布和中涂层施工：先摊铺玻纤布然后刷涂防腐砂浆中涂，每铺一层就在涂刷一道防腐砂浆中涂，直达到玻纤防腐地坪厚度规定的厚度为止； Glass fiber cloth and intermediate coating construction: first spread glass fiber cloth and then brush anti-corrosion mortar coating, each layer on the coating of an anti-corrosion mortar coating, until the thickness of the glass fiber anti-corrosion floor specified; 04 04 腻子层：用环氧防腐中涂材料调配石英砂或双飞粉刮批腻子层，按需要施工二至三道，要求达到平整无孔洞、以利面涂施工； Putty layer: Use epoxy anticorrosive intermediate coating material to prepare quartz sand or double fly powder to scrape a lot of putty layer, according to the need to construct two or three roads, to achieve smooth and no holes, in order to facilitate surface coating construction; 05 05 防腐面涂层：用防腐面漆树脂胶料或色漆涂布二道；注：所用树脂依设计而定，涂刮完毕后用带齿滚洞消泡； Anti-corrosive coatings: two coatings with anti-corrosive top coat resin adhesive or color paint. Note: The resin used depends on the design, after scraping, use with teeth cavity defoaming; |
| 上一页 防腐地坪漆工程中 |
| 下一页 环氧地坪起泡原因 |
Copyright © 技术支持：遨游网络